Which OSI layers offers reliable, connection-oriented data communication services? Refer to the exhibit. The host was disconnected from switch 2 and connected to switch 1. Which combination of IP address, subnet mask, and default gateway should be assigned to this host to allow it to function in the network? IP address: What is the correct destination socket number for a web page request from Host A to the web server?

Author:Naran Mazusida
Language:English (Spanish)
Published (Last):12 November 2014
PDF File Size:20.11 Mb
ePub File Size:5.69 Mb
Price:Free* [*Free Regsitration Required]

Refer to the exhibit. A network administrator is troubleshooting the OSPF network. The What is the probable cause of this problem? Which type of Layer 2 encapsulation used for connection D requires Cisco routers? Which troubleshooting tool would a network administrator use to check the Layer 2 header of frames that are leaving a particular host? A user turns on a PC after it is serviced and calls the help desk to report that the PC seems unable to reach the Internet.

The technician asks the user to issue the arp —a and ipconfig commands. Based on the output, what are two possible causes of the problem? Choose two. Which two WAN technologies are more likely to be used by a business than by teleworkers or home users?

However, the link cannot be established. Based on the partial output of the show running-config command, what is the cause of the problem? The username r1 should be configured on the router R1 and the username r2 should be configured on the router R2. A trust boundary identifies which devices trust the marking on packets that enter a network.

In the creation of an IPv6 ACL, what is the purpose of the implicit final command entries, permit icmp any any nd-na and permit icmp any any nd-ns? Which feature sends simulated data across the network and measures performance between multiple network locations? Which two pieces of information should be included in a logical topology diagram of a network?

A network administrator has configured routers RTA and RTB, but cannot ping from serial interface to serial interface. Which layer of the OSI model is the most likely cause of the problem? Connecting offices at different locations using the Internet can be economical for a business.

What are two important business policy issues that should be addressed when using the Internet for this purpose? What is the network administrator verifying when issuing the show ip interface brief command on R1 in respect to the PPPoE connection to R2? Which QoS mechanism allows delay-sensitive data, such as voice, to be sent first before packets in other queues are sent?

All other users within the school should have access to this server. The list contains the following statements:. A data center has recently updated a physical server to host multiple operating systems on a single CPU. The data center can now provide each customer with a separate web server without having to allocate an actual discrete server for each customer. What is the networking trend that is being implemented by the data center in this situation?

All routers are successfully running the BGP routing protocol. How many routers must use EBGP in order to share routing information across the autonomous systems? Which Cisco feature sends copies of frames entering one port to a different port on the same switch in order to perform traffic analysis?

Which Cloud computing service would be best for a new organization that cannot afford physical servers and networking equipment and must purchase network services on-demand? What is used to exchange routing information between routers within each AS? Which broadband technology would be best for a user that needs remote access when traveling in mountains and at sea?

A company is considering updating the campus WAN connection. Which component of the ACI architecture translates application policies into network programming? Which pillar of the Cisco IoT System allows data to be analyzed and managed at the location where it is generated? A corporation is searching for an easy and low cost solution to provide teleworkers with a secure connection to headquarters.

Which solution should be selected? A vibration sensor on an automated production line detects an unusual condition. The sensor communicates with a controller that automatically shuts down the line and activates an alarm. What type of communication does this scenario represent? The security policy in a company specifies that the staff in the sales department must use a VPN to connect to the corporate network to access the sales data when they travel to meet customers.

What component is needed by the sales staff to establish a remote VPN connection? They should be placed as close as possible to the source of the traffic to be denied. What is used to pre-populate the adjacency table on Cisco devices that use CEF to process packets? A network administrator is testing IPv6 connectivity to a web server.

The network administrator does not want any other host to connect to the web server except for the one test computer. As traffic is forwarded out an egress interface with QoS treatment, which congestion avoidance technique is used?

Name required. Mail will not be published required. The serial interface on Router2 is down. There is an incorrect wildcard mask statement for network What two protocols are supported on Cisco devices for AAA communications? Which three statements are true about PPP? Choose three. PPP can use synchronous and asynchronous circuits. PPP can only be used between two Cisco devices. What protocol should be disabled to help mitigate VLAN attacks?

What is the purpose of the generic routing encapsulation tunneling protocol? The default gateway device cannot be contacted. The network cable is unplugged. The DNS server address is not configured. The subnet mask is configured incorrectly. The IP configuration is incorrect.

The usernames do not match each other. The usernames do not match the host names. The passwords for CHAP should be in lowercase. What function is provided by Multilink PPP? What is the function of a QoS trust boundary? A trust boundary identifies the location where traffic cannot be remarked.

A trust boundary only allows traffic to enter if it has previously been marked. A trust boundary only allows traffic from trusted endpoints to enter the network. Which statement best describes a WAN? A WAN is a public utility that enables access to the Internet. WAN is another name for the Internet. Which statement describes a characteristic of dense wavelength division multiplexing DWDM?

It enables bidirectional communications over one pair of copper cables. It assigns incoming electrical signals to specific frequencies. It can be used in long-range communications, like connections between ISPs.

What are two characteristics of video traffic? Video traffic requires a minimum of 30 kbs of bandwidth. Video traffic latency should not exceed ms. Video traffic is more resilient to loss than voice traffic is.

Video traffic consumes less network resources than voice traffic consumes. Video traffic is unpredictable and inconsistent.

How many DS0 channels are bundled to produce a 1. The list contains the following statements: deny Match OoS techniques with the description. Not all options are used. Which network performance statistics should be measured in order to verify SLA compliance?

What is a disadvantage of a packet-switched network compared to a circuit-switched network? A network administrator is configuring a PPP link with the commands: R1 config-if encapsulation ppp R1 config-if ppp quality 70 What is the effect of these commands? The PPP link will not be established if more than 30 percent of options cannot be accepted. The NCP will send a message to the sending device if the link usage reaches 70 percent. The LCP establishment phase will not start until the bandwidth reaches 70 percent or more.

The PPP link will be closed down if the link quality drops below 70 percent. Which term describes the role of a Cisco switch in the


CCNA 1 Practice Final Exam V4

Last Updated on April 2, by Admin. H1 creates the first Layer 2 header. The R1 router has to examine the destination IP address to determine how the packet is to be routed. If the packet is to be routed out another interface, as is the case with R1, the router strips the current Layer 2 header and attaches a new Layer 2 header. When R2 determines that the packet is to be sent out the LAN interface, R2 removes the Layer 2 header received from the serial link and attaches a new Ethernet header before transmitting the packet. Refer to the exhibit. Which highlighted value represents a specific destination network in the routing table?


CCNA 4 Final Exam V6.0 Answers

Refer to the exhibit. A network administrator is troubleshooting the OSPF network. The What is the probable cause of this problem?


CCNA 2 (v5.03 + v6.0) Chapter 3 Exam Answers for Dynamic Routing




Related Articles